54
Bulb chart
Your Volkswagen is equipped with double
filament seven inch sealed beam units.
Should it become necessary to replace a
sealed beam, loosen the screw of the trim
ring. Firmly grasp the loose screw (non-
removable) and pull the trim ring off.
Headlights
Replacing bulbs
Remove the three short screws in the
sealed beam retaining ring and take the
ring off.
Do not alter the position of the long head-
light adjustment screws.
Take the sealed beam unit out of the
support ring and pull the cable connector
off.
If no other headlight part as described here
was removed or its position changed, it
should not be necessary to aim the
headlights. If in doubt have the adjust-
ment checked by your dealer.
When installing a new sealed beam unit,
be sure the three lugs on the headlight
engage properly in the support ring.
Before installing the trim ring be sure the
rubber gasket is in place. Loosely insert
the screw for the trim ring and turn for
2 or 3 turns. Position the upper edge of
the trim ring over the lug. Press the ring
over the lug and tighten the screw.
Interior lights
N 17 7232
Front turn signal/parking
lights
ZVP 118 034
Sealed beam
(headlights)
ZVP 118 114
Selector lever console
light
(Automatic trans-
mission only)
—
N 17 7512
N 17 7512
License plate light
ZVP 118 089
Stop/tail lights
ZVP 118 034
Rear turn signals
Backup lights
ZVP 118 073
Side marker lights
ZVP 118 057
—
6014
89
1034
1073
57
1034
Warning lights for
emergency flasher
brake operation
rear window defogger
and Auxiliary Heater
Bulb for
VW Part No.
US Re-
placement
bulbs
