Vogt TUBE-ICE 03TA, Service Manual, Page: 94 / 122

03TA Service Manual
SERVICE OPERATIONS
4/2/14
9-12
Thawing Timer.
The thawing timer governs the ice thawing period. It is located inside the control
panel (FIGURE 6-2). It is started by action of the freezer pressure switch (FPS) which energizes the
“CR” relay. This timer is set prior to shipment for approximately a two minute period.
FIGURE 9-12A
Thawing Timer
Set the thawing period for at least 30 seconds longer than the time required to harvest the entire
discharge of ice. If it should be necessary to change the setting of the timer, turn the adjustment
screw clockwise to increase the time or counter-clockwise to decrease the time. Check thaw time
after each adjustment.
FIGURE 9-12B
Thawing Timer Wiring
Timer Part #: 12A7503E22
Syrelec Timer (Orange)
Light
indicates
timer is timing
Light
indicates
timer has
timed out
Time Base:
Set to “min”
Scale: Set to
“X1”
Crouzet Timer (White)
Light flashing when timing
Light Solid when timed out
Range: Set
to “1-10
min”
Voltage rating: 24-240V
Allen Bradley Timer (White)
0
2
4
6
8
10
12
RANGE UNIT
POWER
UP
Min
Range: Set to
“0 to 12”
Time Range
adjustment
0 - 1.2
0 - 3
0 - 12
0 - 30
Power Light (green)
Light blinks while "timing"
Light solid when "timed
out"
Up Light (red)
Light off while "timing"
Light solid when "timed
Unit adjustment
sec
min
hrs
10h
Units: Set to “min”