Vogt TUBE-ICE 03TA, Service Manual, Page: 93 / 122

03TA Service Manual
SERVICE OPERATIONS
4/2/14
9-11
Circulating Water Pump Motor
. The motor bearings are prelubricated and sealed. They require
no further lubrication. The pump should operate with the water level above the impeller housing.
The pump is equipped with a mechanical seal that is self-adjusting and requires no lubrication.
However, the pump should not be operated unless circulating water. The pump manufacturer
recommends that a mechanical seal be kept as a spare. When ordering a seal, specify pump size,
type, serial number, and manufacturer’s name as indicated on the nameplate.
FIGURE 9-10
Water Pump
Cutter Gear Reducer.
The oil level for the gear reducer should be checked if there is evidence of a
leak. It should be level with the plugged opening in the side of the gear housing. Use Mobile 600W
cylinder oil or equal. Change oil once a year.
The motor bearings are prelubricated and require no further lubrication. For additional information,
refer to manufacturer’s instructions.
Note: Ventless gear reducer used after August 2010
FIGURE 9-11
Gear Reducer
Gear Reducer (10:1)
Part #:
12A4030R12
Replacement food grade oil:
Part #: 19 T3020C01
Texaco Cygnus 220
Oil Capacity: 8 ounces
Pump Suction (2” FPT)
Pump Discharge (1 1/2” FPT)
Pump Part #: 12A4020G01
Seal Kit Part #: 12A4080S12
Gear Reducer (5:1)
Crushed Ice Only
Part #: 12A4030R14
Vent Plug
Drain Plug
Oil Level Plug
Vent Plug