Page 6
1.3 Electrical install
1.3.1 Connect the wired remote control (
NO other remote controls, yet
)
1.3.2 Connect 220-230V power
1.3.3 Testing of the lift system
o
Switch on/off switch on
o
Flashing LED, continuous
o
Switch No-movement switch to Normal
o
LED will be off
o
Push Down > lift should go down
o
Push Up > lift should go up
Now you are sure the lift system is working
1.3.4 Setting Show en Service position
Before mounting the projector, approximately set the show and service position. See
chapter 2
Test the system again a few times.
1.4 Optional remote controls
1.4.1 Remote 1 and 2 connectors
o
Remote 1 and remote 2 are for use of the wired remote control (included), an
optional IR remote control or a custom wall switch, automation system, etc.
o
Remote 1 and 2 can both be used at the same time, it are parallel connectors.
o
They switch 5V to ground.
o
Use voltage free contacts in optional remote switches !!
o
Cable: Shielded 0,35mm² for up to 30m or 0,5mm² for up to 150m
1.4.2 Jack (3,5mm) connectors 3x
o
12V IN > control/operate the lift system by external 12V
o
AC aux > control the power of a projector by 12V out
o
12V out > controlling/operating an electrical projection screen by 12V output
See chapter 3 for details
Lift system manual
Summary of Contents for PPL 1515
Page 25: ......
