G406s User Guide Document: G406s-2
----------------------------------------------------------------------------------------------------------------------------- ----------------
15
➢
User can see the image and select Edge to adjust [Overlap] value for Bezel compensation and to
adjust image mis-alignment due to monitor installation issue.
➢
User can use [Overlap] function to stretch the image outside video wall (some image will be missing)
or draw image inside video wall with Black blanking area at the edge. This function can adjust the
aspect ratio of the content to meet required aspect ratio of the video wall. Please see more details in
[Flexible Aspect Ratio Adjustment] section.
➢
Asymmetric video wall can be achieved through overlap adjustment even with different size of
monitor and bezel dimension.
8.4.
Bezel Compensation
➢
Through [Overlap] menu, user can adjust image cropping area and adjust image position.
➢
User can apply test pattern and reduce [Overlap] value to enlarge the image to the bezel center line
between two monitors to achieve bezel compensation.
➢
User can also calculate the pixels number for bezel compensation based on the video wall dimension
and bezel size. If the video wall active display area is 360cm in width and the input source is 3840,
then the pixel number for each centimeter is 3840/360=10.67 pixel/cm. If the bezel size is 12mm in
one edge, then user can decrease Overlap value 10.67*1.2=12.8 (13) pixels to do bezel
compensation for that edge (to enlarge the image 13 pixels at that edge).
9.
OSD Lock and Unlock
➢
User can hold [MENU] key on front panel or remote controller for 5 seconds to lock OSD to prevent
someone to change the settings. After OSD menu is locked, user will see flashing LED on Power
key on the front panel at 0.5
” interval.
➢
User can hole [MENU] again for another 5 seconds to unlock OSD and do further operation.
➢
User can set Box ID for each G406s and control via remote controller:
✓
Press
［
851
］，
all the box OSD will be locked except ID #1 G406s. The [INFO] LED will be
lighted in the locked unit and only ID #1 G406s can be operated.
✓
Press
［
853
］，
all the box OSD will be locked except ID #3 G406s. The [INFO] LED will be
lighted in the locked unit and only ID #3 G406s can be operated.
✓
Press
［
850
］，
all the box OSD will be unlocked and can be operated through remote
controller.
✓
The units have been locked will show flashing Power LED at 1.0” interval.
10. Save and Load system settings
10.1.
Save System Settings through IR remote controller and OSD Menu
➢
After finishing system settings, user can save the setting by OSD menu through [Menu]
→
[Options]
→
[Setting]
→
[Profile]
→
[Save]
→
[Index 1-5].
