VMAC
–
Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
23
□
Attach the two green wires with the ring connectors to a good
ground under the dash.
□
Route the following wires into the engine compartment:
white wire with the blue bullet connector
white wire from the throttle control
red wire from the interface connector
the gray wire with the green four pin connector
the gray wire with the black three pin connector
the long blue wire (automatic transmission only)
□
Insert all of the engine compartment wires (except the long blue
wire) into a plastic loom and route them from the firewall, along
the driver’s side fender, across the top of the radiator to the
compressor. Connect them to the matching connections at the
compressor.
□
Connect the gray wire with the green four pin connector to the
matching connector at the compressor.
□
Connect the gray wire with the black three pin connector to the
matching connector at the compressor.
□
Connect the white wire with the bullet connector to the
compressor clutch.
□
Locate the forward-most connector (C1) at the ECM on the
driver’s side of the engine. Solder and seal the white wire from
the throttle control to the dark blue with gray stripe wire at pin 37
of connector 1 on the ECM (Figure 4.1).
1 5 6 10
51 55 56 60
Pin 37
Backside of connector facing driver’s side of engine
