VMAC
–
Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
16
3.4 Completing the Installation
□
Remove the OEM screws holding the fan to the hub. Use the
VMAC tool 5900220 to countersink the holes and install the
replacement 5/16 inch screws with Loctite.
□
Install the fan spacer, fan, fan shroud and intercooler tube.
□
Insta
ll the driver’s side of the cut fan shroud bracket to the
engine using the supplied bolt and spacer (Figure 3.10). Make
sure that there is sufficient clearance between the bracket and
the OEM belt. Use Loctite on the bolt. Install the fan shroud nuts.
□
Install the fan clutch wire bracket using the supplied bolt, washer,
and spacer (Figure 3.10).
Fan Shroud
Bracket Spacer
Fan Clutch Wire
Bracket Spacer
Figure 3.10
□
Attach fan wiring harness to the fan shroud bracket. Ensure
there is at least a 0.3" gap between the fan wire and the radiator.
□
Route all hoses so that they do not interfere with any moving
components and are not exposed to excessive heat or abrasive
surfaces. Secure them with nylon ties and use plastic loom as
required.
