VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
29
☐
Using the supplied 1 in and 3/4 in heat wrap, protect the 3/4 in and 1/2 in hoses
where they pass below the exhaust (Figure 31).
☐
Install the supplied 3/4 in 45° fitting onto the matching fitting on the rear of the
compressor (Figure 32).
3/4 in 45°
fitting
☐
Connect the straight fitting on the 3/4 in hose to the 45° fitting installed in the
previous step (Figure 32).
☐
Connect the straight fitting on the 1/2 in hose to the matching fitting on the
compressor (Figure 32).
☐
Apply the supplied spiral loom to the (×2) 1/2 in hoses where necessary to
protect them from abrasion (e.g. where it passes through the AOST mount,
where it passes over the body mount, etc.).
☐
Apply the supplied loom to the (×2) PTFE tubes and the black air brake tube.
☐
Install the black 1/4 in air brake tube into the straight fitting on the remote
regulator (Figure 33).
Figure 32 — Connect hoses
Figure 33 — Connect remote regulator tubes
3/16 in PTFE
tube
Black 1/4 in air
brake tube
☐
Install the translucent 3/16 in PTFE tube into the 90° fitting on the remote
regulator (Figure 33).
