6
POWERING THE CAMERA ON
INSTALLING THE BATTERIES
1) Remove the battery compartment cover.
2) Insert the batteries properly into your digital camcorder, according to the polarity shown
inside the battery compartment.
3) Close the battery compartment cover securely.
Use 3 x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
Note:
Remove the batteries from the camera when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
Some camera features (i.e. Flash) will not work if the battery power level is low.
When the battery power is low, the battery icon appears empty and
‘Battery Low’
appears on the LCD screen. The camcorder automatically turns off a few seconds
later.
The energy status of the power is displayed on LCD as shown below:
Full battery power
Medium battery power
Low battery power
INSTALLING THE SD MEMORY CARD
Make sure the SD Memory card (up to 32GB) has been properly inserted into your digital
camcorder. Class 4
SDHC Memory card or higher is required. SD card not included.
To properly insert the SD Card:
1) Push the SD card into the slot in the direction as shown on the SD card icon by the slot on
the digital camcorder.
2) Push the SD card until you hear a slight clicking sound. This indicates the SD card has been
inserted correctly.
Note
:
After the digital camcorder is powered on, an SD icon appears on the LCD display. If
you do not see the SD icon on the display, please check if the card was inserted
properly.
