Vivint SmartHome ELEMENT, User Manual, Page: 57 / 59

57
Vivint Element Installation Guide
Customization
FCC WARNING
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception (which can be determined
by turning the equipment off and on), try to correct the interference by following these suggestions:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications to this receiver not expressly approved by Vivint void the
user’s authority to operate this equipment.
RF Exposure info -- (manual)
This equipment complies with FCC’s and IC’s RF radiation exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this transmitter must be installed and operated to provide a
separation distance of at least 20 cm from all persons and must not be collocated or operating
in conjunction with any other antenna or transmitter. Installers must ensure that 20cm separation
distance will be maintained between the device (excluding its handset) and users.
This Class B digital apparatus complies with Canadian IECS-003. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
C’et appareil numerique de la classe B est conforme á la norme NMB-003 du Canada. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Statement Of Use
100% Compatible with all popular residential HVAC systems: 24VAC single stage and two stage
conventional heating systems (gas, oil, electric), heat pumps with up to two stages of heat and up to two
stages of auxiliary heat (electric or fossil), zoned forced air and zoned hot water (2 or 3 wire), millivolt
systems (a 12- 24V AC or DC source), one or two stage cooling, and hybrid systems. Do not use this
thermostat with with line voltage heating systems.