Vivint SmartHome ELEMENT, User Manual, Page: 26 / 59

26
Connecting the Thermostat to the Panel (Classic Inclusion)
FAILED
NEXT
RE-TRY
SKIP
START
AT
PANEL
1
PRESS
TO
CONNECT
2
SET UP
HVAC
3
press
SIDE
button
press
SIDE
button
press
SIDE
button to
advance
press
SIDE
button
press
SIDE
button to
advance
press
SIDE
button to
advance
see next page
RE-TRY
SKIP
The Vivint Element Thermostat is a Z-Wave
®
compliant thermostat. It can be
operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers. All main operated nodes within the network will act as repeaters
regardless of vendor to increase reliability of the network if not battery operated.
Below describes how to add to the Vivint panel.
1. Set your panel to add node mode to add the thermostat as a node on your
network.
2. The Thermostat main screen shows a welcome message. Press the SIDE button
to continue.
3. When your panel is ready to connect to the Thermostat, press the SIDE button to
connect. This initiates the network connection process. The Thermostat’s screen
says “Connecting.”
• If the connection fails, the screen says, “Failed.” Press the SIDE button to try
connecting again.
4. When the Thermostat has successfully joined a Z-Wave network from the panel,
the screen displays the message “Next”.
5. Complete your setup on the VIVINT panel.
6. Press the SIDE button to continue.
Your panel indicates that the thermostat was successfully added to its network
(see your specific controller’s User Manual for details). To exclude the thermostat
from a Z-Wave network see page 50.
Vivint Element Installation Guide
Setup