Vitris Portavant 80 automatic, Manual

Page: 26 / 38

Portavant 80 automatic 25
Revision 12/2017
9 Approval, inspection and maintenance according to DIN 18650 / EN 16005
The following requirements apply to the operation of the door according to DIN 18650 / EN
16005:

Inspection and approval in accordance with the checklist below before commissioning
by a person trained by the manufacturer

Regular inspection of the automatic doorset at least once a year by a qualified
person

Maintenance after at least 200,000 motion cycles by a qualified person in accordance
with the manufacturer's instructions (the number of motion cycles can be displayed
via the user menu, see operating instructions)
Checklist "Commissioning":

Check technically correct installation according to the manufacturer's instructions

Check sash for smooth operation, adjust, if required

Check doorset for correct function (check of opening, closing and reversing motion
after collision with obstacles)

Check function of installed impulse senders such as radio push button, radio remote
control or hard-wired motion detectors

Installation of effective protective measures against safety hazards or provision of
protection at points between door components and parts of the building structure that
may represent a hazard, e.g. by providing sufficient safety clearances

Correct input of the door weight (see section 7.1 for evaluation of the door weight)

Execution and documentation of the safety analysis in accordance with section 7.1

Creation of a declaration of conformity in accordance with section 7.2

Attachment of inspection label (including the mark of the next inspection)

Documentation of correct commissioning in the inspection record (in this section)

Handing over of manual (and installation instructions) to the operator
Checklist "Annual inspection":

Check sash for smooth operation, adjust, if required

Check doorset for correct function (check of opening, closing and reversing motion
after collision with obstacles)

Check function of installed impulse senders such as radio push button, radio remote
control or hard-wired motion detectors

Check function of protective measures against safety hazards or measures providing
protection at points between door components and parts of the building structure that
may represent a hazard, e.g. by providing sufficient safety clearances

Check electric lines for damage

Check for motor noise

Check fasteners of facing and covers

Check toothed belt for tension and wear

Check all moving parts for correct function, wear and secure fit

Attachment of a new inspection label (including the mark of the next inspection)

Document all checks and maintenance work in the inspection record (in this section)
Care:
Only use commercially available cleaning agents to clean the drive. Keep the drive dry and
do not wipe with a wet cloth. Do not use abrasive cleaning agents.