Portavant 80 automatic
19
Revision 12/2017
7.2
Declaration of conformity by installer
The manufacturer of the door drive (Willach) has attached a CE mark at the drive system
(incomplete machine) and has provided proof of type-approval and classification according
to DIN 18650 to the greatest possible extent.
Declaration of conformity by the installer (manufacturer/installation contractor):
The installer incorporates the door drive with the fittings, the sash (not included in scope of
supply of door drive manufacturer) and the peripheral building structure. According to the
Directive on Machinery 2006/42/EC, only this procedure turns the incomplete machine into a
complete machine. The installer or the contractor performing the installation thereby
becomes manufacturer or assembler of the complete machine, i.e. the complete doorset.
The doorset must be tested for its conformity with the Directive on Machinery (Safety
analysis, see section 7.1 as well as Directive on Machinery 2006/42/EC and DIN 18650/EN
16005). Proof of conformity must be documented by providing a CE declaration. To this end,
the drive system manufacturer (Willach) requests the doorset installer to utilise the CE mark
provided on the drive and to complete the classification in accordance with DIN 18650 so
that it applies to the complete doorset.
The first six digits and the eighth digit of the classification have already been printed onto the
label on the drive unit by the manufacturer (Willach).
Classification DIN 18650 I
2
I
1
I
2
I
0
I
1 3
I
0
I
__ __ __
I
4
I
1st digit:
Drive type
2
Sliding door drive
2nd digit:
Durability of the drive
1
200,000 testing cycles
3rd digit:
Door type
2
Sliding door
4th digit:
Fire-protection door suitability
0
Not suitable as fire-protection door
5th digit:
Safety devices at drive
1
Force limitation
3
Low (kinetic) energy
6th digit:
Special requirements for drive
0
No special requirements
7th digit:
Safety measures at automatic doorset
?
To be determined by installer
8th digit:
Ambient temperature
4
Temperature range according to
drive manufacturer's specifications
The 7th digit must be entered by the installer as follows:
0
– No additional safety devices
1
– With sufficiently dimensioned safety clearances
2
– With protection against crushing, shearing and drawing-in of fingers
A "0" indicates that no safety devices are installed. Such safety devices may be permanently
installed protective wings for instance. (Note: It is not possible to fit the Portavant 80
automatic system with sensor edges.)
Digit "1" indicates that all safety clearances are sufficiently dimensioned. See fig. a) to f) in
section 7.1 (in general, the ">" symbol).
Digit "2" indicates that measures have been implemented against crushing, shearing and
drawing-in of fingers. These measures may be implemented e.g. by observing the
clearances according to fig. a) to f) in section 7.1. Suitable covers of excessively large gaps
(e.g. for in-wall systems) may also be suitable measures.
Summary of Contents for Portavant 80 automatic
Page 1: ...Manual EN Gebr Willach GmbH Stein 2 53809 Ruppichteroth Germany...
Page 33: ...Portavant 80 automatic 32 Revision 12 2017 12 2 EC Declaration of Conformity...
Page 34: ...Portavant 80 automatic 33 Revision 12 2017 12 3 Type examination by T V...
