Transcendent VT-TR5HA DVR Series
49
Select one auto mode to pop up the corresponding window. Set the encode, resolution, FPS,
bitrate type, quality, max bitrate and audio of each camera and then click “OK” to save the
settings. Please adjust the parameters according to the actual condition.
Video Encode
: the video encode format of the camera.
Resolution
: the higher the resolution is, the clearer the image is.
FPS
: the higher the frame rate is, the more fluid the video is. However, more storage will be
needed.
Bitrate Type
: CBR and VBR are options. CBR means that no matter how much the video
changes, the compression bitrate stays the same. This will not only facilitate the image quality
better in a constant bitrate but also helps to calculate the capacity of the recording. VBR means
that the compression bitrate can be adjustable according to the changing of the video resources.
This will help to optimize the network bandwidth.
Quality
: When VBR is selected, you need to choose image quality. The higher the image
quality you choose, the more bitrate will be required.
Max Bitrate
: 32Kbps ~10240Kbps are options.
Ø
Manual Mode
If the manual mode is selected, you need to set the encode parameters and record schedules of
each camera. See 7.2 Encode Parameters Setting and 7.3 Schedule Setting for details.
Transcendent VT-TR5HA DVR Series
50
7.1.2 Advanced Configuration
Click Start
à
Settings
à
Record
à
Advanced to go to the following interface. Enable or disable
cycle record (cycle record: the earliest recorded data will be replaced by the latest when the
disks are full). Set the pre-alarm record time, post-alarm record time and expiration time of
each camera and then click “Apply” to save the settings.
Pre-alarm Record Time
: set the time to record before the actual recording begins.
Post-alarm Record Time
: set the time to record after the actual recording is finished.
Expiration Time
: set the expiration time for recorded video. If the set date is overdue, the
recorded data will be deleted automatically.
7.2 Encode Parameters Setting
Click Start
à
Settings
à
Record
à
Encode Parameters to go to the interface as shown below. Set
the encode, resolution, FPS, bitrate type, quality, max bitrate and audio of main stream for each
camera in “Event Recording Settings” and “Schedule Recording Settings” interfaces. Click
“Apply” to save the settings. You can set the record stream of each camera one by one or batch
set them for all cameras.
Click Start
à
Settings
à
Record
à
Stream Settings to go to “Sub Stream” interface. Set the
encode, resolution, FPS, bitrate type, quality and max bitrate of sub-stream for each camera in
the interface and then click “Apply” to save the settings.
