Transcendent VT-TR5HA DVR Series
13
2
Basic Operation Guide
2.1 Startup & Shutdown
Please make sure all the connections are done properly before powering the unit. Proper startup
and shutdown are crucial to extending the life of your device.
2.1.1 Startup
�
Connect the display device to the VGA/HDMI interface of the DVR.
�
Connect the mouse and power. The device will boot and the power LED will turn blue.
�
A WIZARD window will pop up (you should select the display language the first time you
use the DVR). Refer to 3.1 Startup Wizard for details.
2.1.2 Shutdown
Power off the device by using the remote control or the mouse.
By remote control:
�
Press Power button. This will take you to a shutdown window. The unit will power off
after clicking “OK” button.
�
Disconnect the power.
By mouse:
�
Click Start
à
Shutdown to pop up the Shutdown window. Select “Shutdown” in the
window. The unit will power off after clicking the “OK” button.
�
Disconnect the power.
2.2 Remote Controller
�
Uses two AAA size batteries.
�
Open the battery cover of the remote control.
�
Insert batteries. Please observe the polarity (+ and -).
�
Replace the battery cover.
Key points to check in case the remote doesn’t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR control sensor for any masking.
If it still doesn’t work, please try a new remote control, or contact your dealer.
There are two kinds of remote controls. The interface of remote control is shown as below.
Button
Function
Power Button
Turns unit on and off
