VITEK Industrial Video Products – Transcendent Series NVRs
97
②
Select the camera, enable tripwire detection by IPC and set the duration.
Note
: Some models may support tripwire detection by NVR.
③
Select the direction.
Direction
: A<->B, A->B and A<-B optional. It is the crossing direction of the target that crosses
over the alert line.
A<->B
: the alarm triggers when the target crosses over the alert line from B to A or from A to B.
A->B
: the alarm triggers when the target crosses over the alert line from A to B.
A<-B
: the alarm triggers when the target crosses over the alert line from B to A.
④
Draw line. Refer to the interface as shown above. Check “Draw line” and then drag the
mouse in the image to draw an alert line. Uncheck the “Draw line” if you finish the drawing.
Click the “Clear” to delete the alert line.
⑤
Click “Detection Target” to choose the detection target and the sensitivity. The detection
target includes people, vehicle, and non-vehicle. Only some IPCs can detect human or vehicle
separately. If the camera does not support this function, please skip this step.
⑥
Click “…” to choose “Save original picture” or “Save target picture” on the SD card of the
camera. (If your camera does not support this function, please skip this step).
⑦
Click “Trigger Mode” to configure tripwire alarm linkage items.
l
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up
Video” and “E-mail”. The alarm linkage settings are the same as the face detection alarm (see
9.1.1 Face Detection Settings for details).
l
Enable “IPC Audio” or “IPC Light” as needed (only some IPCs support these two functions).
To set the IPC voice and its times and volume, please refer to 11.5.6 Audio for details. To set the
light flashing time and frequency of the IPC, please refer to 11.5.7 Light for details.
⑧
Click “Apply” to save the settings.
Summary of Contents for VT-TNR1646PF
Page 185: ...NOTES ...
