VITEK VTC-TNB2LPR
21
4.3
PTZ Configuration
This function is only available for the model with RS485 interface. It can be used with a
compatible external PTZ enclosure.
Go to PTZ
à
Protocol interface as shown below.
4.4
Alarm Configuration
4.4.1
Motion Detection
Go to Alarm
à
Motion Detection to set motion detection alarm.
1. Check “Enable” check box to activate motion-based alarms. If unchecked, the camera will
not send out any signals to trigger motion-based recording to the NVR or CMS, even if there is
motion in the video.
Alarm Out:
If selected, this would trigger an external relay output that is connected to the
camera on detecting a motion-based alarm. (For the models with two alarm output interfaces,
two alarm output can be selected.)
Trigger Snap:
If selected, the system will capture images on motion detection and save the
images on a SD card.
Trigger SD Recording:
If selected, video will be recorded on a SD card on motion detection.
Trigger Email
: If “Trigger Email” and “Attach Picture” are checked (email address must be set
