Installation
49
© 2015 Vision Engraving Systems
B1 button
- The B1 button is used to set the spindle lift height when moving between
characters. To set the Z lift from the VE810 front panel, follow the steps below:
a) Press the B1 button.
b) The LCD display will show the current lift distance.
c) Press the Z up or down arrows to increase or decrease the Z lift distance. The changes will be shown
on the LCD screen. Pressing the Z up and down arrows changes the distance in 0.01" increments (.25
mm). Holding the ALT button down while pressing the Z up and down arrows will change the distance in
0.1" increments (2.5 mm).
d) Press the Start button to save the Z lift distance or press the Stop button to cancel the change.
NOTE:
The Z lift height can be set from the Vision Pro software. When the Engrave icon is selected,
select the icon with three dots to the right of All Tools as shown below.
Change the Z lift height value to the desired distance and select OK. The job will now be sent to the
machine with the value entered.
+
ALT + B1 button
- When you hold down the ALT button and press the B1 button,
the current status of the Spindle Motor, Aux, Proximity Sensor, Z Surface location, offset position and Z
lift distance will be stored into the machine and used as the default settings. To use this feature, adjust
all of the settings listed above on the front panel as desired. Once they are correct, hold the ALT button
down and press the B1 button. The Save Settings screen will appear on the LCD. Press Start to save the
default settings into the machine or Stop to abort saving the settings. Once complete, the settings will
remain in the machine even after it is powered off and back on.
