Installation
43
© 2015 Vision Engraving Systems
spindle speed knob up a little bit. The spindle speed also has presets based on the material selected in
the Vision software.
Start button
- The start button is used to start the engraving machine. When there is a job in
the VE810, the green light above the start button will be flashing on and off. When it is flashing, pressing
the start button will start engraving. Also, if you have pressed the pause or stop button to stop the
engraving, pressing the start button will resume the job. When a job is ready to be engraved, the LCD
screen will also display:
If a job has been sent to the machine and has been run, the start button has another feature. If you are
using the Connectivity Manager (not Machine Tools), pressing the start button after the job has been
run, will recall the job. Pressing the start button once more will run the same job.
+
ALT + Start button
When connected via Connectivity Manager - Pressing ALT + Start with no job in the machine will
attempt to connect to your
computer. You will need to press Stop twice in order to reset the machine. If
there is a job in the machine, this function will perform a dry run of the job with the red pointer on the
machine. The red pointer will outline the job to be engraved.
When connected to Vision Machine Tools - If there is no job in the machine, pressing ALT + Start will
display a list of jobs that are stored on the computer's hard drive. Use the Y up and down jog buttons to
move the cursor on the LCD screen to the job to be engraved and then press start to load the job into
the machine. Pressing start a second time will run the job. If a job is in the machine and ready to be
engraved, pressing ALT + Start will perform a dry run of the job with the red pointer on the machine.
The red pointer will outline the job to be engraved.
(Screen shown if using Vision Machine Tools only)
Pause button
- The pause button is used to momentarily stop the machine from engraving. If
you press the pause button while the machine is engraving, the VE810 will lift the cutter up from the
material and stop engraving. The spindle motor and vacuum will power off while in Pause mode.
Pressing the Start button will resume the engraving where it left off and pressing the stop button will
cancel the job. When in Pause mode, the LCD screen will display: