Vision Research Phantom v1211, Manual

Page: 79 / 88

Chapter 9: Support
73
•
Power Out (24VDC, used to power the Break-out-
Box)
•
A-Sync output (optionally, signal goes low when
a trigger event is detected by the Image-Based
Auto-Trigger feature allowing for multiple cameras
to be synchronized to an event trigger)
•
Pre-trigger / Memgate input (mode is set in
software; if Memgate is low, acquired frames are
discarded rather than saved to camera memory;
Pre-trigger signal “arms” the camera and starts
the acquisition of pretrigger frames)
Detailed information about these signals is available using
the PCC application’s Help feature.
All Phantom v2511, v2011, v1611 and v1211 cameras
ship with a standard Capture Cable that connects to the
Capture Connector and provides access to:
•
Ready
•
Strobe
•
A-Sync
•
Pre-trigger / Memgate
•
Video
All other signals are accessible by using a Phantom
Break-out-Box. See the related FAQ.
Yes it will. You can connect through the remote port on
the camera either with a “Remote” cable or Bluetooth
dongle. You can also use an RCU connected via the
Break-out-Box.
If you connect using the remote port on the camera then
you will also have to connect to one of the HD-SDI outputs
of the camera to see video on the RCU.
Connecting through the Break-out-Box provides NTSC
or PAL video to the RCU
Will the Phantom Remote
Control Unit (RCU work with the
Phantom v2511, v2011, v1611, or
v1211 cameras?