36
7.9 MOTOR REPLACEMENT
1) Turn off power and remove the power cord from the unit.
2) Remove the motor cover as outlined in Section 7.1.
3) Use a hook or loop of wire to remove the spring from the drive belt tensioner (Figure A).
4) Remove the mounting bolt of the tension wheel set using a 5mm Allen Wrench (Figure B). Be careful to hold the tension wheel set as it will
drop once the mounting bolt is removed.
5) Disconnect the motor cable from the MCB and cut any tie straps holding the cable in place (Figure C).
6) Disconnect the motor ground wire from the motor and cut any tie straps holding the ground wire in place.
7) Use an 8mm Allen Wrench to remove the 4 motor mounting screws (Figure D), and remove the motor.
8) Reverse Steps 1-7 to install a new motor.
NOTE:
Torque the screws removed in Step 4 to 35 N-m and those removed in Step 7 to 10 N-m.
9) Test the treadmill for function as outlined in Section 7.15.
FIGURE A
FIGURE B
FIGURE C
FIGURE D
CHAPTER 7: PART REPLACEMENT GUIDE