42
7.15 TESTING THE TREADMILL
ONCE THE TREADMILL OR REPLACEMENT PART IS FULLY INSTALLED AND ASSEMBLED, USE THE
FOLLOWING INSTRUCTIONS TO SETUP AND TEST THE MACHINE.
1) If the treadmill was just assembled, or if any electronic component was replaced (or the console cable was unplugged for any reason), the
treadmill must be auto calibrated. See Section 3.3.
2) If the treadmill was just assembled, or if the running belt, deck, or rollers are replaced, the belt should be centered and tensioned as outlined
in Section 3.2.
3) Once Auto Calibration has been run, and the belt is centered and tensioned, press the GO key on the display. Listen for any unusual
squeaks or other noises.
4) Press the INCLINE up key until the treadmill goes to maximum incline, then lower back down to the minimum incline using the INCLINE
DOWN key. Listen for any unusual squeaks or other noises.
5) Press the SPEED UP key until the treadmill goes to maximum speed, then lower back down to the minimum speed using the SPEED DOWN
key. Listen for any unusual squeaks or other noises.
6) Grasp the heart rate grips to check for proper heart rate response.
7) Press and release the Emergency Stop to test the stop and to return to normal operation.
CHAPTER 7: PART REPLACEMENT GUIDE
