VISIOMED Baby Doo Cleaner MX6-ONE, User Manual

Page: 10 / 48

Visiomed BABYDOO MX6-ONE - V6 - 012017 Visiomed BABYDOO MX6-ONE - V6 - 012017 17 16
Disposal of empty battery to the authorized place.
Collecting party subject to the regulation of each individual territory.
If the unit is not used for a long period, please take out all batteries to
avoid liquid leakage damaging the unit.
DEVICE ASSEMBLING
1 - After inserting the batteries , (when using
for the first time), place a disposable hygienic
cap in the special compartment .
2 - Make sure the silicone joint is properly
positioned , allowing the internal baby
nose cleaner to be sealed.
3 - Place the cover back in place, and turn
until the device is sealed closed.
MAKE SURE THE 4 NOTCHES OF THE COVER
AND THE MAIN UNIT ARE FACING EACH OTHER
.
4 - Place a probe .
5 - Fill the sterile bottle with saline solution
and screw it on the site set for this purpose –
the aspiration pump being inside the bottle.
GENERAL ADVICE FOR USE
1 - Turn on the BABYDoo
®
by pressing the switch button in front
of the central unit.
2 - Insert carefully the probe in the nostril while holding baby’s
head to help it breath..
3 - When you press the saline solution diffuser button for one to
two seconds the aspiration stops and the saline solution is diffused into the
baby’s nose. Release the button, the aspiration begins again. This should
be done once only for each nostril at each use. Do not instill too much sa-
line solution to avoid any contamination risk of the middle ear. Make sure
1
4
5
6
7
8
SPARE ACCESSORIES
- Réf. : MX-CAPS - Box of 100 spare
hygienic caps
- Réf. : KITEMB3-6 - Box of 3 Hypoal-
lergenic silicone probes and 2 silicone
joints
Accessories are available in pharma-
cies and baby stores
BATTERY INSTALLATION
1 - Remove the battery cover by pulling on the lower section of the BABY-
Doo
®
Cleaner MX6-One nose cleaner.
2 - Insert the 2 alkaline AA batteries and make sure the polarity is correct.
A polarity error may cause damage and affect the warranty.
Never insert chargeable batteries. Use single use batteries. Do not mix
the new and old batteries together.
3 - Replace the battery cover.
2
3
1
6 5
4
7
8
2
3
Open / Close