VIRTUFIT Elite Comfort, User Manual

Page: 19 / 40

EN
VirtuFit Elite Comfort Treadmill
19
TROUBLE SHOOTING
There is no signal when power on
• First check whether the over load protector is open or not, if opened, please close it.
• Make sure the wire of the switch, over load protector and driver are connected well.
• Make sure the wire between the monitor and driver is connected well.
The display shows E01 after switch on
• There something wrong with the signal cable. Please check each cable between display and the
driver is ok or not.
• There are something wrong with the display component part, please replace the display.
• Replace the transformer.
The display shows E02 after switch on
• Check the motor cable is ok or not, if not please reconnect the motor cable. If it does not work, please
replace the motor.
• Check the controller whether there is any special smell. If so please replace the controller.
• Check whether the input voltage is correct or not. Please use the right input voltage.
The display shows E03 after switch on-----no sensor signal
• If the motor start working for about 5-8 seconds and then the monitor displays E03. E03 stands for
there is no speed signal. Please check whether the speed sensor is connected well or not. In addition
please check whether the sensor is broken or not.
• The sensor wire on the PCB board is broken, please replace the PCB board.
The display shows E04 after switch on - failure of the ramp
• Check whether the cables are properly seated in the ramp motor.
• Check the AC motor wire of the ramp motor, make sure it is connected correctly on the control panel.
• After checking all the wires, press the LEARNING button on the control plate to select one perform
slope calibration.
The display shows E05 after switch on-----overload protection
• The treadmill is overloaded, please restart
• Perhaps a part has jammed causing the engine to be overweight, preventing the machine from
operating. Adjust or lubricate the treadmill with a little oil.
• Check the engine for a distinct odor or overload noise. If so replace than the engine.
• Check the control board; replace it if necessary.
MALFUNCTION AND SOLUTION