User Manual CopyBox Standard CD-DVD Duplicator -
12. Advanced Setup
Page 23 van 29
•
Select the desired time the drive trays must remain open between each
cycle. This is a time can be selected between 10 and 180 seconds.
•
S elect the required number of simulations with the "Up" or "Down"
button. The options are 1 to 1000, or "Run Continuous".
12.7 Update Firmware
This function should only be carried out in consultation with your supplier.
12.8 Compare Firmware
This function should only be carried out in consultation with your supplier.
12.9 H/W Diagnostic
This function allows testing of the CopyBox hardware.
•
Select the "H / W Diagnostic" option from the "Advanced Setup" menu
with the "Up" or "Down" button and press "Enter" button.
•
The hardware test will start. Follow the instructions on the LCD display.
All tests are shown on the LCD display.
•
When the entire test is completed successfully the following message
appears on the LCD display.
12.10 Load Default
This function allows all CopyBox controller settings to be overwritten with the factory defaults.
•
Select the "Load Default" option from the "Advanced Setup" menu with
the "Up" or "Down" button and press "Enter" button.
•
Select "Yes" or "No" with the "Up" or "Down" button and press "Enter"
button.
•
When the factory settings are loaded, the following message appears
on the LCD display.
12.11 CD+G
This feature is not supported by the CopyBox DVD±RW burners.
Test finished
Sel burn-in num:
Run Continuous
12-09. Adv Setup
H/W Diagnostic
↑
↓
Enter ESC
Hold ESC to exit
Load Default
OK
12-10. Adv Setup
Load Default
Load Default
Config ? Yes
Sel Trayout Time
30 sec
