Manual VIPA System 300S SPEED7
Chapter 4 Deployment
HB140E - CP - RE_341-2CH71 - Rev. 09/46
4-7
The properties of the CP may be accessed by a double click at the CP,
which corresponds to the protocol you want.
Every parameter of the CP may be accessed by the registers
Address/ID
and
Parameter Assignment
.
By presetting a start address for the input respectively output area the
beginning of the address area of the CPU may be determined, which is
mapped by the module. Please regard that the base address for input and
output are identical.
Each interface occupies 16byte. The data of the COM2 interface are
allocated with an offset of 16byte.
The corresponding address value is necessary for integration in the user
program. To access the COM2 interface you have to add 16 to the
respective address value.
With the process image a consistent image of the process signal may be
accessed during the program cycle.
If the field
process image
shows the entry "---" then the set address area is
outside the process image. The entry "OB1-PA" indicates that the set
address area is within the process image.
Here the parameters, which correspond to the protocol, may be preset.
More information concerning this may be found at chapter "Communication
Protocols".
Properties
CP 341-2CH71
Address/ID
Output
Input
Process image
Parameter
Assignment
Summary of Contents for CP 341S
Page 1: ...VIPA System 300S SPEED7 CP 341 2CH71 Manual HB140E_CP RE_341 2CH71 Rev 09 46 November 2009 ...
Page 4: ...Contents Manual VIPA System 300S SPEED7 ii HB140E CP RE_341 2CH71 Rev 09 46 ...
Page 8: ...Safety information Manual VIPA System 300S SPEED7 4 HB140E CP RE_341 2CH71 Rev 09 46 ...
Page 70: ...Index Manual VIPA System 300S SPEED7 A 2 HB140E CP RE_341 2CH71 Rev 09 46 M Stich ...
