Chapter 4 Deployment
Manual VIPA System 300S SPEED7
4-2
HB140E - CP - RE_341-2CH71 - Rev. 09/46
Fast introduction
The integration of the CP into your SPS system should take place with the
following proceeding:
•
Assembly and commissioning
•
Hardware configuration (integration CP in CPU)
•
Protocol parameters
•
Communication with the user program
•
Install your SPEED-Bus system with a SPEED7 CPU and a CP 341.
•
Wire-up the system. A detailed description about this may be found in
the chapter "Assembly and installation guidelines".
•
Switch power ON.
→
After a short boot time the CP is in the system
without any protocol.
•
Start the Siemens SIMATIC manager with an online connection to the
CPU. More about this may be found in the manual of the CPU.
Note!
For the deployment of the System 300S modules at the SPEED-Bus you
have to include the System 300S modules into the hardware catalog via the
GSD-file SPEEDBUS.GSD from VIPA.
•
Install the SPEEDBUS.GSD from VIPA.
•
For hardware configuration jump within your project to the hardware
configurator of the Siemens SIMATIC manager.
•
Insert a profile rail.
•
Place the following Siemens CPU at slot 2: CPU 318-2DP
(6ES7 318-2AJ00-0AB0/V3.0) and parameterize the CPU if necessary.
•
If there are modules at the standard bus right beside the CPU and
parameterize the modules if necessary.
The project engineering of the SPEED-Bus modules happens by means of
a virtual Profibus DP master system. For this, place as last module a DP
master (342-5DA02 V5.0) with master system.
•
Now include for the CPU and every module at the SPEED-Bus a slave
system "VIPA_SPEEDBUS".
•
Set as Profibus address the slot no. (100...110) of the module and place
the according module from the hardware catalog of VIPA_SPEEDBUS
to slot 0 of the slave system.
•
In this way place the SPEED-Bus CP 341-2CH71 according to your
protocol. In the hardware catalog for each protocol at VIPA_SPEEDBUS
a CP 341-2CH71 is available.
Overview
Assembly and
commissioning
Hardware
configuration
Summary of Contents for CP 341S
Page 1: ...VIPA System 300S SPEED7 CP 341 2CH71 Manual HB140E_CP RE_341 2CH71 Rev 09 46 November 2009 ...
Page 4: ...Contents Manual VIPA System 300S SPEED7 ii HB140E CP RE_341 2CH71 Rev 09 46 ...
Page 8: ...Safety information Manual VIPA System 300S SPEED7 4 HB140E CP RE_341 2CH71 Rev 09 46 ...
Page 70: ...Index Manual VIPA System 300S SPEED7 A 2 HB140E CP RE_341 2CH71 Rev 09 46 M Stich ...