Manual VIPA TM
Chapter 3
Deployment
HB39E - TM - RE_900-2H611 - Rev. 10/16
3-23
Depending on the access modes to your Teleservice module, there are the
following possibilities to preset IP address parameters:
Access via Ethernet
Enter here IP address and subnet mask of your TM. The IP address
parameters must correspond to the IP address parameters, which were
preset with the software tool "eBuddy".
Access via VPN connection
With a Teleservice module, which communicates via Talk2M, the IP
address may be found in the communication software "eCatcher".
As soon as a connection to the Teleservice module is established, the IP
address is shown in the "eCatcher".
Open the properties dialog of the communication component "MPI/DP" of
"TM-H". Enter the MPI address. This must correspond to the MPI address
preset by the software tool "eBuddy".
NetPro should now show the following structure:
Click in the graphical net view at the CPU and transfer your project with
Download
>
Selected stations
.
Now your CPU may be accessed via this connection from the Siemens
SIMATIC manager.
Define access via
IP address
Set the MPI
address
Transfer the
project to the CPU
Summary of Contents for 900-2H611
Page 4: ...Contents Manual VIPA TM ii HB39E TM RE_900 2H611 Rev 10 16...
Page 8: ...Safety information Manual VIPA TM 4 HB39E TM RE_900 2H611 Rev 10 16...
Page 70: ...Chapter 3 Deployment Manual VIPA TM 3 44 HB39E TM RE_900 2H611 Rev 10 16...
Page 72: ...Index Manual VIPA TM A 2 HB39E TM RE_900 2H611 Rev 10 16 M Stich...
