VIPA 900-2H611, Manual

Page: 23 / 72

Manual VIPA TM
Chapter 2 Hardware description
HB39E - TM - RE_900-2H611 - Rev. 10/16 2-5
By means of the Ethernet WAN interface the TM may be accessed via
Internet by the DSL router or an existing local network.
The interface is automatically adapting to the transfer rate 10 or 100Mbit/s.
The jack has the following assignment:
8-pole RJ45 jack:
Pin Assignment
1 Transmit +
2 Transmit -
3 Receive +
4 -
5 -
6 Receive
-
7 -
LINK
ACT
8 -
LED Meaning
LINK on: Das TM is physically connected to the Ethernet.
ACT blinks: The TM communicates via Ethernet (Activity)
The WAN interface does not support "autosense", this means for
connection a crossed Ethernet cable or a switch is to be used.
The TM is delivered with the following IP address parameters for the WAN
interface:
IP address: 10.0.0.53
Subnet mask: 255.255.255.0
Gateway: 0.0.0.0
To change the IP address parameters the configuration tool "eBuddy" from
VIPA may be used.
Note!
Per default the WAN interface is always de-activated. For the first
connection the LAN interface is to be used.
RJ45 Ethernet-
WAN interface
LEDs (green)
Connection via
Ethernet