28
EN
press
1
and
to confirm.
After confirming the operation, wait for completion of the cancellation process.
Default: no association.
Note:
You can use the codes from 201 to 204 [from INITIAL ID + 1000 to INITIAL ID + 1007, from 1001 to 1008 by
default], for the concierge switchboards.
A code without remapping cannot be called by this electronic unit, unless you have configured either a traditional
button or one of
and
.
2.6 - Search
the
entire
contacts
list
With this item, the electronic unit can be configured to scroll through the entire contacts list by entering a blank name
as the search string. Normally, at least the first letter of the name to be searched should be entered With the FLAG
selected, press
then
or
to see respectively the first and last names in the contacts list, whatever the initial
letter.
The
and
buttons can then be used to scroll through the entire contacts list. To enable the setting, press
1
and
confirm with
. To deactivate the function, press
0
+
and
.
In the case of Horizontal Installation other codes that change the function are possible. They are:
BUTTON
SEARCH THE ENTIRE CONTACTS LIST...
2
ABC
NO, and with the keypad calls are allowed only if there is a corresponding name in the
contacts list.
3
DEF
YES, and with the keypad calls are allowed only if there is a corresponding name in the
contacts list.
4
GHI
NO, and with the keypad calls are allowed only if the ID is within the start-end range.
5
JKL
YES, and with the keypad calls are allowed only if the ID is within the start-end range.
Default: No
2.7 - Device names
R
The electronic units have an electronic contacts list for 200 [1000] users. Each user can be assigned two names (a
and b) of 16 characters each.
Use the
buttons or key in the
to select one of the 200 [1000] users.
Each user is matched with two names (
a
and
b
), to be selected with buttons
. Having located the required
line, press the
button to change the value. Once change mode is activated, the blinking cursor will show where
to enter the character.
To enter characters / symbols, use buttons
0
+
to
9
WXYZ
. Each button has more than one character/symbol associated
with it (see table 3). To find the desired symbol, press the button repeatedly before the end of the 2 second timeout,
which is renewed with each press of the button. If the symbol entered previously was an upper case character, even
if the button is changed, the function will restart with upper case. If the symbol was lower case, the function will restart
with lower case. If the symbol was a digit, the function will restart with a digit. To enter a character / symbol located on
a different button from the one previously pressed, it is not necessary to wait for the end of the timeout.
When entering symbols, the
and
buttons can be used to scroll along the line, and the
R
button to delete
the character to the left of the cursor. Press
to confirm the change. After confirmation, the electronic unit will
check whether or not the name entered is already used in another position. If it is already used the display will show
a message similar to this:
and it will be necessary to enter another name. When searching for uniqueness, uppercase and lowercase letters are
distinct. Whereas when searching for a call there is no distinction.
Note:
You can use the codes from 201 to 204 [from INITIAL ID + 1000 to INITIAL ID + 1007, from 1001 to 1008 by
default], for the concierge switchboards.
Default: blank.
2.8 - Programming password
Sets the password for access to configuration from keypad. Enter the new password using buttons
0
+
to
9
WXYZ
. Press
2.6
Search all Contacts
2.7
Contacts name
2.8
Password
