Villager VCPS 0820, Original Operating Instructions, Page: 41 / 234

17
Villager VCPS 0820 (EN)
5.3 Using the shoulder strap
Warning!
Always use the shoulder strap when working with the equipment. Switch
off the equipment before you take off the shoulder strap (risk of injury).
1.
Hook the carabiner (Fig. 4/Item A) into the strap holder.
2. Slip the shoulder strap (Fig. 12/Item 8) over your shoulder.
3. Adjust the length of the shoulder strap so that the strap attachment is at waist
level (Fig. 12).
4. The shoulder strap is equipped with a buckle. Press the hooks together (Fig. 13)
if you need to put down the equipment quickly.
5.4 Adjusting the angle of the handle (Fig. 14)
Press the safety lock-off (5) and adjust the angle of the handle (2) to any of 5
latching positions.
5.5 Adjusting the angle of the motor housing (Fig. 15)
Press the two safety lock-offs (11) and adjust the angle of the motor housing (12) to
any of 3 latching positions.
5.6 Adjusting the telescopic tube (Fig. 16)
1. Undo the telescopic tube lock nuts (9).
2. Pull out the telescopic tubes (10) to suit the required working height.
3. Secure the telescopic tube lock nuts (9).
5.7 Fitting the battery (fig. 17-18)
Press the side pushlock button (T) of the battery pack as shown in Fig. 17 and push
the battery pack into the mount provided. When the battery pack is positioned as
in Fig. 18, make sure that the pushlock button latches in place! To remove the
battery pack, proceed in reverse order.
5.8 Charging the battery (fig. 19)
1. Take the battery pack out of the equipment. Do this by pressing the pushlock
button (T).
2. Check that your mains voltage is the same as that marked on the rating plate of
the battery charger. Insert the power plug of the charger (21) into the mains
socket outlet. The red LED will then begin to flash.
3. Insert the battery pack (1) into the battery charger (21).
4. In the section entitled „Charger indicator" you will find a table with an
explanation of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, check: