Villager SILENT FORCE VAT 264/50, Original Operation Manual, Page: 29 / 138

11
TANK PRESSURE GAUGE
Gauge shows pressure in tank indicating compressor is building pressure properly.
MAINTENANCE
Disconnect power source then release all pressure
from the system before attempting to install, service,
relocate or perform any maintenance.
Check compressor often for any visible problems and follow maintenance procedures each time
compressor is used.
1. Pull ring on safety valve and allow it to snap back to normal position.
Safety valve must be replaced if it cannot be actuated or it leaks air after ring
is released.
2. Turn compressor off and release pressure from system. Drain moisture from tank by opening drain
cock underneath tank.
3. Clean dust and dirt from motor, tank, and airlines and pump cooling fins while compressor is still
OFF.
IMPORTANT: Locate unit as far from spraying area, as hose will allow preventing overspray from
clogging filter.
LUBRICATION
This is an oilless type compressor requiring no lubrication.
THERMAL OVERLOAD PROTECTOR
This compressor is equipped with an automatic reset thermal overload
protector, which will shut off motor if it becomes overheated.
If thermal overload protector shuts motor OFF frequently, look for the following causes:
1. Low voltage.
2. Clogged air filter.
3. Lack of proper ventilation.
If the thermal overload protector is actuated, the motor must be allowed to
cool down before start-up is possible. The motor will automatically restart without warning if left
plugged into electrical outlet and unit is turned on.
STORAGE
1. Kada nije u upotrebi, skladištite creva i kompresor na hladnom i suvom mestu.
2. Drain tank of moisture.
3. Disconnect hose and hang open ends down to allow any moisture to drain.