Villager JGP 1100 F, Original Instructions Manual, Page: 12 / 95

3
Villager JGP 1100 F (GB)
15. Please don't bend, extrude, pull or drive the power wire to avoid the related
dangers caused by line breakage.
16 Please check the plug and power cable before application. When the power
cable has been damaged, please disconnect the plug immediately. Please don't use
the equipment which has damaged power line.
17. When the equipment is idle, please ensure that the plug has been pulled out.
Meanwhile, the equipment has been closed, then, unplug the power supply.

As for the fixed application, please apply four screws to tighten the equipment
on the foundation support firmly.

When the equipment is used for the pound and swimming pool in the garden,
the equipment shall be subject to the special setup to avoid the overflow and
falling.

The equipment shall be installed in the well-ventilated places to avoid the
weather effect. In case of indoor operation, please ensure that the floor is
equipped with drainage ditch or leakage-proof mechanism.

Please check the suction hose and guarantee its airtightness before startup.
When the air foam is absorbed in the hose, the equipment is likely to be out of
order because the leakage exists possibly.

All interfaces which are connected to the suction pipeline shall be sealed by
hemp and thick slurry or sealing tape. The leakage will reduce the air exhaust.

The interface of metal pipe thread shall be sealed by sealing tape.

All components of suction pipeline shall be installed by professionals.

The inner diameter of suction pipe shall be 25mm at least; The suction pipe
shall be kinking resistant and suitable for the vacuum environment.

Considering that the increasing pipe length will reduce the transmission
capacity, the suction pipeline shall be as short as possible.

The suction pipeline shall uplift the pump steadily to avoid any bubbles.
Danger type and source!
In order to avoid any mechanical force or tension, the suction pipeline
shall be installed.
When the transmission pipeline is polluted, please apply filter to
make cleaning and
protection.
Danger!
Attention:
We advise to install one check value to avoid the equipment
shutdown which is caused by water loss absence during the pump.