5
Installation and Mounting
Side View
of the K-1900-7-IP
(8) #6-32 x 3/4" Stainless Steel T-10
Torx Security Screws (included)
Optional VE-5x10 Surface
Mount Box (not included)
- OR -
10.0"
9.5"
4.50"
5.00"
3.28"
1.55"
Front View
of the K-1900-7-IP
1.8"
2.75"
2.1"
3.5"
Double Gang Box
(not included)
2.69”
10.14”
5.22”
3.69”
4.50”
9.50”
2.75"
2.1"
3.5"
Double Gang Box
(not included)
Side View of
the K-1900-6-IP
(4) #6-32 x 3/4" Stainless Steel,
Flat Head T-10 Torx Security
Screws and Drive Bit (included)
4.5"
1.8"
4.56"
3.28"
Front View
of the K-1900-6-IP
To install the
K-1900-6-IP
panel phone, attach the panel to a standard double gang electrical box using the provided screws.
Tip
: Record the MAC address that is printed on the network jack. This number will be used later in programming.
A. Installing the K-1900-6-IP
B. Installing the K-1900-7 -IP
To install the
K-1900-7-IP
panel phone, attach the panel to a standard double gang electrical box using the provided
screws or use the optional
VE-5x10
or
VE-5X10-SS
weather resistant surface mount box.
Note:
Four extra screws
and nuts are provided to fill the unused mounting holes.
The optional
VE-5x10
surface mount box (shown below) is
designed to be surface mounted to a wall, post, single gang box or a
VE-GNP
or
VE-GNP-2
goose neck pedestal. The
K-1900-7-IP
can also be mounted in an optional
VE-9x20
Weatherproof Enclosure (
DOD 413
).
Note:
When mounting a
K-1900-7-IP-EWP
in a
VE-9x20
, the length of the handset cable must be reduced. Use a
3/32” hex key or bit to loosen the set screw in the brass handset cable retainer. Pull approximately 18 inches of the
cable through the panel and retighten the set screw.
Tip: Record the MAC address that is printed on the network jack. This number will be used later in programming.
