12
13. Ring Cadence
When “Inbound Call Mode” on the
K-1900-6/7-IP
is set to “Ring Low” or “Ring High,” the Ring cadence can be programmed
to one of 4 different cadences:
Normal Ring
(single ring, 2 sec on 4 sec off) factory setting
Double Ring
(double ring, 1 sec on .5 sec off 1 sec on 3.5 sec off)
Short-Short-Long
(triple ring, .5 sec on .5 sec off .5 sec on .5 sec off 1 sec on 3 sec off)
Short-Long-Short
(triple ring, .5 sec on .5 sec off 1 sec on .5 sec off .5 sec on 3 sec off)
The Inbound Call Mode determines how the
K-1900-6/7-IP
handles incoming calls. One option is to generate a ring sound
through the handset receiver, allowing someone to lift the handset to answer the inbound call. The
K-1900-6/7-IP
can also
auto answer the call, to allow remote control of the doorstrike relays and the ability to listen to transmit audio from the handset
of the phone. The last option is the silent monitor mode, which allows callers to listen to the transmit audio from the handset
of the phone at a much higher volume than normal. The “secure” options for auto answer and silent monitor require the callers
to dial the access code in order to remain connected and listen to the audio from the handset.
Disabled
– Inbound calls are not allowed.
Auto Answer
– Inbound calls are auto answered and the caller hears transmit audio from the handset at a normal volume
level.
Auto Answer Secure
– Inbound calls are auto answered and the caller must dial the access code in order to listen to transmit
audio from the handset (volume level is still normal).
Ring Low
– In the “low” mode the phone will output a ring signal out of the earpiece in the ring pattern selected in Ring
Cadence. The call can then be answered by taking the handset off hook.
Ring High
– In the “High” mode the phone will output a slightly louder, higher pitched ring signal out of the earpiece in the
ring pattern selected in Ring Cadence. The call can then be answered by taking the handset off hook.
Silent Monitor
– Inbound calls are auto answered and the caller hears transmit audio from the handset at a much higher
volume level.
Silent Monitor Secure
– Inbound calls are auto answered and the caller must dial the access code in order to listen to transmit
audio from the handset (volume level is still at a much higher volume level).
12. Inbound Call Mode
The access code comes into play when a tenant calls the
K-1900-6/7-IP
and a visitor lifts the handset to answer the
call or the
K-1900-6/7-IP
automatically answers the call (see Inbound Call Mode). It is a 1 to 6 digit code (can not
contain “
Q
” or “#”) that the tenant must dial before they are allowed to operate the door strike relays, as extra security
on inbound calls. Once a tenant has entered the correct access code, 2 beeps are heard and the user can now enter
any “Remote Access Operation Commands” (see page 15). The access code can be disabled if this basic security is
not required. This code is also used to enable transmit audio for silent monitoring.
11 . Access Code
10. Security Code
The security code allows the user/installer to program the
K-1900-6/7-IP
phone with a PC and the required ‘Viking IP
Programming” software. The factory set security code is 845464. If the security code of the phone is left as default, the
PC software will not require entering a security code to connect to the phone. It is recommended that the factory set
security code be changed.
Note:
The security code must be 6 digits and cannot include a
Q
or a
#
.
