4
Wiring
Rear View of the
Phone Panel
Ring Connector
(included)
* Earth Ground
(optional)
** Gel-Filled Butt
Connectors
(included)
Note: Polarity Sensitive!
*** Drip
Loop
BLK-4 Control
Module
(included)
rotated 90°
(-) Black with
Red stripe
120V AC
(+) Red with
Black stripe
Red (+)
Black (-)
Green (see section F page 6)
Rear View of the SL-2
Strobe Light
(included)
see Programming page 6
Red with
Yellow stripe
Green with
Yellow stripe
Brown
Gray
Auxiliary Relay Contact Output
(see section D on page 5)
Blue
Blue
Incoming
Analog
Phone Line
Phone or
Terminal
Device
(not included)
Purple
Orange
Yellow
12V DC
Adapter
(included)
White
White
Disable Feature
(see section E on page 6)
Note:
Not polarity sensitive.
Trigger Input for Optional
Remote Trigger Switch
(see section G on page 6)
Rear View of Legacy
SL-1 Strobe Light
(included with 2012 and older
E-1600A-BLT-EWP
models)
Black
Red
Negative
Positive
1
3
3
2
ON
ON
* Note:
To increase surge protection, loosen the PCB mounting screw labeled (as shown) and fasten a wire with ring connector
(included) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
IMPORTANT:
Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the
telephone line. It is recommended that a surge protector be installed to protect against such surges.
** Note:
The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a maximum
insulation of 0.082 inches. Cut off bare wire ends prior to terminating.
*** Note:
When wires are routed from above, a “drip loop” is recommended to keep water away from the circuit board.
DIP Switch 4 OFF
DIP Switch 4 ON
N.C.
+12VDC Normally ON
COM
+12VDC
N.O.
+12VDC Normally OFF
