Disassembly
©2010 Viking Preferred Service
29
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Oven Light Bulb Removal
Condition Requirements:
Door Lowered
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the
access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto
metal box.
1
2
3
4
Top Light Housing Removal
Condition Requirements:
Control Components Accessed
1. Remove lens and bulb.
2. Disconnect connector for top light.
3. Use a screw driver to depress two tabs in top light
housing and tilt side of housing down to remove.
4. Reverse procedure for installation.
Door Lock Assembly Removal
Condition Requirements:
Control Components Accessed
1. Remove screws and door lock assembly from range.
2. Mark and disconnect connectors from door lock
assembly.
3. Remove door lock assembly and door latch insulation
from range.
4. Reverse procedure for installation.