Disassembly
©2010 Viking Preferred Service
23
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Motor Capacitor Removal
Condition Requirements:
Control Board Accessed
1. Mark and disconnect wires from capacitor.
2. Remove nut, lockwasher, and capacitor from lower
mounting plate.
3. Reverse procedure for installation.
Door Assembly Removal
Condition Requirements:
Door Lowered
1. Place pins supplied with unit in pin holes.
Important:
For personal safety, only use pins supplied
with unit. Pins can be ordered if needed #005116-000.
2. Remove screws and hinge trim from range.
3. Gently close door until pins stop door.
4. Lift door up and out.
Door Assembly
Adjustment Screw
Note:
If the door needs to be adjusted, loosen hinge
trim screws. Adjust the screws located between
the door and kick plate using a
5
/
32
" hex head
allen wrench. Tighten hinge trim screws after
adjustment is made.
5. Reverse procedure for installation.
Door Gasket Removal
Condition Requirements:
Door Lowered
1. Insert a narrow tool or small, flat-blade screwdriver
into the center of each clip and pry upward.
2. Remove the door gasket from two holes in the bottom
of the door liner.
3. Reverse procedure for installation.