58
10.3 Quick Reference Sheet cont.
TruProtect
™
“
Advanced” Function “
Quick
” R
eference
Function / Feature
Description
Control Confirmation / Comment
Service Diagnostics Mode
To enter and exit Service Diagnostics Mode, press and hold the “
W
ARMER
” key
while pressing the “COLDER
” key four (4) times in five (5) seconds. Service Diag
-
nostics Mode will automatically exit after five (5) minutes of no keypad entry
.
Display Error Code Reference:
The microprocessor in the control continually monitors critical refrigeration system
components for proper operation. If component parameters exceed normal opera
-
tion specifications, the display will automatically flash the respective error code as
follows:
E1
Compressor Error (High/L
ow Amps)
E2
Condenser F
an Error (L
ow Amps)
E3
Upper Compartment “Sensor A
” Error (Out
-of-Range)
E4
Lower Compartment “Sensor B
” Error (Out
-of-Range)
Please call your dealer or Viking Customer Service if any of these codes are
displayed.
Service Diagnostics Mode enables service technicians to identify the firmware
and software versions, test status of “model specific” system components and
sensors, and change the state of components where applicable, (i.e. compres
-
sor on/off
, etc...). While in Service Diagnostics Mode, tests are incremented by
pressing the “SET” key
, and specific component states can be changed to “
ON”
and “
OFF
” by pressing the “
W
ARMER
” and “COLDER
” keys respectively
. The
following component tests are available:
Test #
Component Description
A
vailable Status Indicators
OK
Off/
Open
On/
Shorted
0
Temperature Sensor
, Upper
0-
00
01
1
Temperature Sensor
, L
ower
1-
10
11
2
Compressor
n/a
20
21
3
Condenser F
an
n/a
30
31
4
Compartment F
an, Upper
n/a
40
41
5
Compartment F
an, L
ower
n/a
50
51
6
Heater/F
an Assembly
, Upper
n/a
60
61
7
Heater/F
an Assembly
, L
ower
n/a
70
71
8
Door Sense
n/a
80
81
NO
TE
: The Door Sense is located between the Upper Compartment display and
the ON/OFF key and can be tested with any magnet.
2010 - Viking Preferred Service
SMR-0005
Summary of Contents for DFUW244CL
