10
Boiler position
The following limitations must be
observed when siting the boiler:
■ The boiler is not suitable for external
installation. The position selected for
the installation should be within the
building, unless otherwise protected
by a suitable enclosure and must
allow adequate space for installation,
servicing and operation of the appli-
ance and for air circulation around it.
■ The position must allow for a suitable
flue system and terminal position.
The boiler must be installed on a flat
vertical wall capable of supporting the
weight of the appliance and any
ancillary equipment when full.
■ Due consideration should be given to
the routing of the condensate drain
from the chosen position.
■ If the boiler is to be fitted in a timber
framed building it should be fitted in
accordance with ige/up/7. If in doubt
advice must be sought from the Insti-
tute of Gas Engineers.
■ If the appliance is to be installed in a
room containing a bath or shower,
any electrical switch or control utilis-
ing mains electricity must be so situ-
ated that it cannot be touched by a
person using the bath or shower.
Attention is drawn to the require-
ments of BS 7671 (the current I.E.E
Wiring Regulations) and in Scotland
the electrical provisions of the Build-
ing Regulations applicable in Scot-
land.
■ A compartment used to enclose the
appliance must be designed and con-
structed specifically for this purpose.
An existing cupboard or compartment
may be used provided it is modified
accordingly. BS 7698:2000 gives
details of the essential features of
cupboard / compartment design,
including airing cupboards. The
Vitodens range does not require
compartment ventilation.
■ Where installation will be in an
unusual location, special procedures
may be necessary. BS 6798 gives
detailed guidance on this aspect.
Installations requirements
(cont.)
5780 223 GB
Summary of Contents for Vitocaldens 222-F
Page 58: ...58 5780 223 GB ...
Page 59: ...59 5780 223 GB ...
