Vidicode SD2750, Manual

Page: 27 / 69

Call Recorder Single Digital manual ©Vidicode 2011-2014 27
Note1:
Note1: Note1:
Note1: When connecting the Single Digital to the line in this mode,
synchronization to the phone and PBX must be found. This procedure
disturbs the working of the phone for a short while with intervals of
about 10 seconds, until the recorder is synchronized. This usually takes
less then 1 minute.
Note2: Note2: Note2: Note2: The notification message is not available anymore when In-Line
mode is disabled!
•
Press ---- or + + + + to alter the line input amplification.
•
Press NEXT
NEXT NEXT
NEXT to continue in the menu or press STOP
STOP STOP
STOP to exit the
settings menu.
4.9 Notification
In some countries or regions notification during the recording of
telephone conversations is obligatory. Check local regulations and
obligations.
Notification can be with a spoken message at the beginning of the call
or at the moment the recording is started. A notification message could
be for example: “For security reasons our calls are being recorded”.
Following the Protocol setting as described above
•
Press CHANGE to set the Notification method to Incoming,
Outgoing, Always or Off.
These options work as follows:
When "Incoming
Incoming Incoming Incoming" is selected the message will only be played when an
incoming call is answered.
When "Outgoing
Outgoing Outgoing
Outgoing" is selected the message will only be played when an
outgoing call is answered.
In-Line mode: Yes
NEXT CHANGE STOP
Notification: Off
NEXT CHANGE STOP