Videx 2 Wire, Manual

Page: 14 / 44

Two Wire Videokit ESVK Series
PrtCode:ESVK_ENG_1.6.doc – Pag.14/44 25/11/2009 Rev.1.6
EXTENSION NO – SW3.2..3
If the intercommunication between apartments is enabled (switch 1 of SW3 = ON) leave these two switches in default position (both to OFF). Otherwise,
if the intercommunication is between the same apartment (switch 1 of SW3 = OFF), set the extension addresses starting always from 1. During the ex-
ternal call, all video monitors in the same flat will ring but the video will be shown only from the videmononitor with extension address 1.
2 3 Extension No.
OFF OFF 1 (default, master)
ON OFF 2 (slave)
OFF ON 3 (slave)
ON ON 4 (slave)
SLAVE MODE - SW3.4
This set up concerns the answering mode of the video monitor when there is more than one unit (max 4) in the
same apartment. OFF (default) = during a call, only the video monitor with extension 1 (master) will show the
video. ON = the video monitor will be switched on independently of the extension address: in this case the
video monitor must be supplied locally using a power supply Art.2321 and connecting respectively BUS+ to
terminal 14 and BUS- to terminal 11 of the pcb connection board provided with the Art.5980.
PRIVACY UNLIMITED – SW2.1
If this switch is set to OFF (default), the privacy duration is defined by switches 2 and 3.If this switch is set to
ON, the privacy duration is unlimited and the service can be enabled or disabled only by the privacy button.
PRIVACY DURATION – SW2.2..3
This set up requires that switch 1 is set to OFF.
2 3 Duration
OFF OFF 15 minutes
ON OFF 1 hour
OFF ON 4 hours
ON ON 8 hours
VIDEOMONITOR CONNECTION BOARD ART.5980
Fig.3
SIGNAL ON CONNECTION TERMINALS
Terminal Signal Description
1 GND Ground
2 BUS1 Bus input
3
4 BUS2 Bus input
5 S1 Terminal controlled by the S1 button, close to GND until the button is pressed
6 LED Auxiliary LED power supply input (12Vdc)
7 S2 Terminal controlled by the S2 button, close to GND until the button is pressed
8 GND Ground
9 GND Ground
10 LB Local bell input (active low)
11 GND Ground
12
13
14 +VAUX Auxiliary power supply input (to be used when the switch 4 of SW3 is set to ON)
15
16
17
18 AL
Alarm input (not implemented yet)
19
20