Videx 2 Wire, Manual

Page: 19 / 44

Two Wire Videokit ESVK Series
PrtCode:ESVK_ENG_1.6.doc – Pag.19/44 25/11/2009 Rev.1.6
ART.5188 INTERCOM WALL MOUNTING INSTRUCTIONS
Fig.1 Fig.2 Fig.3
Fig.4 Fig.5 Fig.6
A
B
135cm
a
b
c
d
e
g
h
A
B
−
As shown in Fig 1, looking at the rear of the intercom, insert the tip of a flat blade screwdriver into one of the two openings (Fig 1A ) then slightly move
the screwdriver in an upward direction to release the front from the back plate and opening the intercom unit (Fig 1B ).Take care! The back plate of the
intercom houses the pcb connection board which is normally connected to the pcb in the front of the intercom by the ribbon cable, the ribbon cable
should not be connected when first opened.
−
Place the back plate of the intercom against the wall at approximately 135cm (Fig 2) above finished floor level, then mark the fixing holes taking into
account that the cable group “
a ” must feed into the opening “ b ” (Fig 3).
−
As shown in figure 3, fix the back plate of the intercom to the wall feeding the cable group “ a ” through opening “ b ”.
−
Using a flat blade screwdriver connect the wires to the pcb connection board “ c ” as shown in Figure 4, according to the installation diagram provided.
−
Connect ribbon cable plug “ d ” from the front plate into plug “ e ” on the pcb connection board as shown in Figure 5.
−
Close the intercom by hooking the front plate “ g ” to the back plate “ h ” as described below:
ƒ Hook the top of the front plate “ g ” to the top of the back plate as shown by pointer “ A ” in Figure 6.
ƒ Move the lower side of the front plate “ g ” towards the back plate“ h ” and press until the unit locks into the back plate of the intercom.
To open the intercom once installed, firmly grasp the bottom sides of the front plate cover, pull forward in an upward direction to separate the front cover
from the back plate as in Figure 6.
NB. Please take care when opening to avoid damage, remember that the ribbon cable connects the front plate to the back plate connector
pcb.
SPECIFICATION
Housing/Mounting
5000 Series Intercoms / direct wall mount
Push buttons Yes, 4
Programming
Yes, carried out by the dip-switches located on the rear of the videophone
Controls Loudspeaker and call tone volume
Power Supply Supplied by the BUS line
Working Temperature -10 +50 ºC
CUSTOMER SUPPORT INFORMATION
All Countries Customers UK Customers
VIDEX Electronics S.p.A.
www.videx.it – technical@videx.it
Tel.+39 0734 631669
Fax +39 0734 632475
VIDEX Security LTD
www.videx-security.com
Tech Line 0191 224 3174
Fax 0191 224 1559
The product is CE marked demonstrating its conformity and is for distribution within all
member states of the EU with no restrictions.
This product follows the provisions of the European Directives
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) and 93/68/EEC (CE marking). Il prodotto è marchiato CE a dimostrazione della sua conformità e può essere distribui-
to liberamente all’interno dei paesi membri dell’unione europea EU.
Questo prodotto è conforme alle direttive Europee
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) e 93/68/EEC (Marcatura CE).