Videotec WAS, Instruction Manual

Page: 13 / 84

Instruc
tion manual - English - EN
11 MNVCWAS_1744_EN
7 Maintenance
7.1 Fuses replacement
Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
The operation is performed only for a pump
with a 5m or 11m delivery head.
Check the causes that caused the fuse breakage.
In the event the problem occurs again, contact the
technical assistance service.
7.1.1 Replacing the fuse of the pump
board
The used fuse is described below.
• T 4A H 250V: BUSSMANN S505-4-R or
OMEGA GT520240
As an alternative, use an approved fuse featuring the
same characteristics.
For further information refer to the relative
chapter (6.5.1 Installing the fuse, page 9).
7.1.2 Replacing the fuse on the pump
inlet
The used fuses are described below.
Pump with 5m (16ft) delivery:
• T 2A L 250V: BUSSMANN S506-2-R or
OMEGA ST522220
Pump with 11m (36ft) delivery:
• T 4A L 250V: BUSSMANN S506-4-R or
OMEGA ST522240
As an alternative, use an approved fuse featuring the
same characteristics.
Once the box is open identify the fuse position.
Fig. 12
8 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm .
For more information on proper disposal of these
devices, you can contact the responsible public
service.