Instruc
tions manual - English - EN
51
MNVCUPTMAXB_1511_EN
10.1.10.3 Washer Menu
The unit offers the possibility to use a wiper and to
operate a pump to clean the glass.
To configure the Washer put the lens of the camera in
front of the nozzle of the Washer.
Save a preset (XY) that identifies this position; the
preset will be recalled by the pan & tilt when the
WASHER function is enabled.
Configure the following parameters:
1.
Enable:
Enabling the Washer function.
2.
Nozzle Preset:
Enter the preset number (XY)
corresponding to the nozzle.
3.
Wiper On Delay:
Select the time interval
between the pump and wiper.
4.
Washing Length:
Choose the duration of
brushing.
5.
Wiper Off Delay:
Choose the duration of
brushing without water.
WASHER
------------------------
1>ENABLE : N
2 NOZZLE PRESET : 1
3 WIPER-ON DELAY : 5
4 WASHING DURATION : 10
5 WIPER-OFF DELAY : 5
Fig.
114
10.1.11 Default Menu
1.
Delete Setup?
: Resets all the parameters except
the Presets.
2.
Delete Preset?
: Deletes all previously stored
presets.
DEFAULT
------------------------
1>DELETE SETUP?
2 DELETE PRESET?
Fig.
115
The above mentioned operations cause the
loss of all previously stored data (i.g. Preset,
Patrol, Autopan, Home…).
10.1.12 Info Menu
The menu is used to check the configuration of the
device and the installed firmware version.
INFO
------------------------
Device ID: 00001
Type : Rs485 only Rx
Baud Rate: 38400-8N1
Protocol : MACRO
Net Board: Fw6.02 Hw01
Mpp Board: Fw6.02 Hw00
Config. : 001
P.C. : UPT1SVSA000E
S.N. : 000000000000
Upgrade : NET BOARD
Fig.
116
