7
FITTING SEAT (OPTIONAL)
If your product came with a seat you may choose
to install this item.
Before commencing full assembly of the product
you will need to prepare and fi t the seat.
You need to drill three holes for the fi xing bolts
into the tower at your preferred height.
Drill the holes in the central tower to the
measurements shown in the diagram below.
Remove the three fi xing nuts from the threaded
ends on the rear of the seat fi xing plate.
Pass the threads of the seat through the holes from
the front of the tower panel.
At the rear, pass the threads though the white
support piece (white plastic) and then fasten the
bolts to hold.
Ensure the bolts are FULLY tight.
The seat has a MAX allowance
for use of 100kg
Summary of Contents for Essence Range
