Victoria VITTORIA 8 Instruction Manual Download Page 16

Page: 16 / 24

Victoria-05 Ltd.

12.

Maintenance.

Disconnect the power supply of the pellet stove before performing any activity

Vacuum the combustion chamber before each ignition. If combustion break, do not light a pellet stove again until you have
emptied and cleaned the combustion chamber.

The wood pellets, which are subtracted from the combustion chamber, should not be back in the pellet fuel hopper!

To operate properly, the pellet stove must be regularly serviced. If you do not perform regular maintenance (thorough cleaning
at least once per season), this may lead to impaired operation of the pellet stove. Any problems arising from lack of cleaning lead
to void the warranty.

12.1. Daily cleaning

For better heat exchange and reduction of fuel consumption, it is necessary to clean the openings of the combustion chamber
daily when the stove is cold.

Picture.5.

Picture.6.

Picture.7.

Clean the pellet stove with a vacuum cleaner only when it is completely cold. The procedure takes a few minutes.

Open the fire door and throw away the ashes from the ashtray (Picture.7);

Open the door and remove the combustion chamber or use the spatula to scrape off any scales that clog the holes
(Fig.6);

Vacuum the combustion chamber and the space under it;

Clean the glass when it is cold. If necessary, use appropriate detergent.

Never vacuum hot coals, because this may damage the vacuum cleaner!

12.2. Weekly cleaning.

Empty the pellet fuel hopper and clean with a vacuum cleaner if the pellet stove was not used for an extended period.

Clean the ignition.

12.3. Seasonal maintenance (performed by the installer).

The user has to contact the installer, to perform the seasonal maintenance.

Disconnect the power supply of the pellet stove, before performing any activity!

Clean pellet stove internally and externally;

Carefully clean and remove dirt and ashes from the combustion chamber and related divisions;

Carefully remove the vermiculite plate at the top of the combustion chamber and clean the dirt and ashes;

Clean the dirt in the flue channels behind the cast iron plate - position

(А).

To do this, first dismantle the two side

plates

–

position (B); Fig. 5

–

and then the rear plate by unscrewing the six M6x25 screws. After cleaning the flues,

the back plate

–

position (A)

–

and the side plates

–

position (B) - are installed. The screws must be lubricated with

heat-resistant graphite grease.

Clean, check and remove all debris from the ignition system;

Clean propulsion parts and electric motors. Make sure there are no gaps;

Clean and check the room fan;

Check sensors;

Check and, if necessary, replace the battery on the control panel;

Clean and check the electronic control system;

Check all electrical cables;

Clean the pellet fuel hopper and check auger for loosen screw and the gear motor;

Check and if necessary replace the door seal;

Make a functional test, insert a small amount of wood pellets in the hopper enough to fill auger. Light a pellet stove
for 10 minutes and shutdown.

Before lighting the fireplace (after cleaning it) make sure that the combustion chamber is placed correctly.
If maintenance procedures are not performed regularly, the guarantee shall be considered invalid!