2
VE106 Groove-N-Go Tool
OPERATOR SAFETY INSTRUCTIONS
The VE106 Groove-N-Go tool is designed only
for roll grooving pipe/tubing. Use of this tool
requires dexterity and mechanical skills, as
well as sound safety habits. Although this tool
is designed for safe, dependable operation, it
is impossible to anticipate all the combina-
tions of circumstances that could result in an
accident. The following instructions are rec-
ommended for safe operation of this tool. The
operator is cautioned to always practice
“safety first” during each phase of use, includ-
ing setup and maintenance. It is the responsi-
bility of the owner, lessee, or user of this tool
to ensure that all operators read this manual
and fully understand the operation of this tool.
Read this manual before operating or servic-
ing this tool. Become familiar with the tool’s
operations, applications, and limitations. Be
particularly aware of its specific hazards.
Store this manual in a clean area where it is
always readily available. Additional copies of
this manual are available upon request
through the Victaulic Tool Company.
1.
This tool is designed ONLY for roll
grooving pipe/tubing sizes, materials, and
wall thicknesses listed in the "Tool Rating
and Roll Selection" section, starting on
page 28.
2.
Avoid using the tool in dangerous
environments.
Do not expose the tool to rain,
and do not use the tool in damp or wet loca-
tions. Do not use the tool on sloped or uneven
surfaces. Keep the work area well lit. Allow
sufficient space to operate the tool properly.
3.
Ground the drive motor to protect the
operator from electric shock.
Make sure the
drive motor is connected to an internally
grounded electrical source.
4.
Prevent back injury.
This tool is heavy.
When removing from or placing into a truck or
van, two people can lift the tool more safely
and faster than one.
5.
Inspect the equipment.
Before using
the tool, check all moveable parts for any
obstructions. Make sure tool components are
installed and adjusted properly.
6.
Prevent accidental startups.
Be careful
not to depress the safety foot switch uninten-
tionally.
7.
Wear proper apparel.
Do not wear loose
clothing, jewelry, or anything that can become
entangled in moving parts.
8.
Wear protective items when working
with tools.
Always wear safety glasses,
hardhat, foot protection, and hearing protec-
tion.
9.
Stay alert.
Do not operate the tool if you
are drowsy from medication or fatigue. Avoid
horseplay around the equipment.
10.
Keep visitors away from the immedi-
ate work area.
All visitors should be kept a
safe distance from the equipment at all times.
11.
When using this tool on an elevated
floor or platform, the area below must
remain clear of other personnel.
12.
Keep work areas clean.
Keep the work
area around the tool clear of any obstructions
that could limit the movement of the operator.
Clean up any oil or other spills.
13.
Secure the work, machine, and acces-
sories.
Make sure the tool is stable. Refer to
the "Tool Setup" section on page 6.
14.
Support the work.
Support long pipe/
tubing lengths with a pipe stand that is
secured to the floor or the ground.
15.
Operate the tool only with a safety foot
switch.
The drive motor must be operated
with a safety foot switch that is located for
easy operator access. Never reach across
moving parts. If the tool does not contain a
safety foot switch, contact Victaulic.
16.
Keep hands and tools away from
grooving rolls during the grooving opera-
tion.
Grooving rolls can crush or cut fingers
and hands.
17.
Do not reach inside the pipe/tubing
end during tool operation.
TM-VE106 3736 Rev_B.fm Page 2 Monday, May 9, 2005 12:02 PM
