20
VE106 Groove-N-Go Tool
3.
Remove the drive key from the rear of the
shaft.
4.
Store the drive key, hex bolt, and lock
washer into the safety-foot-switch storage box
to prevent the items from being misplaced.
5.
Using a punch and hammer (these tools
are not furnished), tap the lower roll/main
shaft out from the rear of the tool, as shown
above.
6.
Pull the lower roll/main shaft out from the
front of the tool head. Using a soft cloth,
remove any debris and excess grease from
the lower roll/main shaft.
7.
Store the lower roll/main shaft in a holder
located on the tool cart.
8.
Follow the "Lower Roll/Main Shaft Instal-
lation" section on page 22.
TM-VE106 3736 Rev_B.fm Page 20 Monday, May 9, 2005 12:02 PM
