2.
Grasp the tool with one hand, then use the
other hand to push the lower roll into the tool .
3.
Using the hex key provided, reinstall the lower
roll retaining stud .
UPPER ROLL REPLACEMENT
1.
Replace the upper roll and upper roll shaft
into the slide assembly . To confirm proper
installation, verify that the part code stamp on
the upper roll faces the operator . Also verify
that the upper roll groove feature aligns with the
lower roll pocket . Tighten the set screw until
hand-tight .
MAINTENANCE
This section provides information about keeping
the tool in proper operating condition .
LUBRICATION
1.
After every 8 hours of operation, lubricate the
three grease fittings on the tool with EP2 lithium
grease .
NOTE:
Safety guard removed for clarity .
2.
Once per week, use EP2 lithium grease to
lubricate the groove diameter adjustment screw .
To make room for lubrication, move the groove
diameter adjustment nuts to the top of the
threaded rod . Remove the lower roll, then lower
the slide assembly until the groove diameter
adjustment nuts bottom out on the tool head .
18
REV_A
TM-RG1210
/ Operating and Maintenance Instructions Manual
Summary of Contents for RG1210
Page 2: ......
Page 22: ...This page intentionally blank ...
